wireguardConfigGenerator.sh

Generates config for wireguard
-h - prints this help
-n <name> - gives a name to the config
-c <count> - number of clients to generate for. Mutually exclusive with "-u"
-s <ipv4_second> - sets the second byte of the ipv4
-i <ipv4_third> - sets the third byte of the ipv4
-e <endpoint> - ip address or domain name (required)
-p <port> - listen port of server (defaults to 50000)
-k - enables persistent keepalive for clients
-o <directory> - output dir to place configs (required)
-u <subnet> - subnet to use (default 24). Mutually exclusive with "-c"
-f <ipv4_fourth> - must use with "-u" to set partial fourth byte
-x <ipv6_template> - set template, "x" will be replaced (must be last)
-d - disable ipv6 addresses

Note that subnets must not conflict between configurations if they are loaded on the same machine.

For example, to generate two different server/clients configs with differing subnets, you can run the following:

# For 10.1.1.0 to 10.1.1.15 (10.1.1.0 and 10.1.1.15 is reserved)
# For fc00:1:0 to fc00:1:f (fc00:1:0 and fc00:1:f is reserved)
./wireguardConfigGenerator.sh -n first -s 1 -i 1 -f 0 -u 28 \
    -e example.com -p 50001 -o conf_output_dir1 -x fc00:1:x
# For 10.1.1.16 to 10.1.1.31 (10.1.1.16 and 10.1.1.31 is reserved)
# For fc00:2:0 to fc00:2:f (fc00:2:0 and fc00:2:f is reserved)
./wireguardConfigGenerator.sh -n second -s 1 -i 1 -f 16 -u 28 \
    -e example.com -p 50001 -o conf_output_dir2 -x fc00:2:x

If ipv6 is not desired, you can skip specifying -x ... and use -d to disable ipv6 generation.